Var lib ntp drift not updating bbw singles dating north carolina
I've resorted to running ntpd -q using cron every hour which works fine and I believe shows that the the basic setup is OK (firewall, ntp server list, etc).
Without the ntpd -q workaround in place and with ntpd service running ntpq -p returns: [email protected]:~ # ntpq -p remote refid st t when poll reach delay offset jitter ================================================== ============================ 2.38 184.108.40.206 2 u 53 64 377 91.542 15716.2 3917.39 admin.montelena .134 3 u 26 64 377 93.725 10744.3 3931.11 220.127.116.11 2.238 2 u 26 64 377 69.612 11875.0 3138.09 The drift file contains: [email protected]:~ # cat /var/lib/ntp/drift -79.065 and a typical hourly ntpd -q reports: ntpd: time set 59.922030s Should these match (or at least be close and on the same side of zero)? I would suggest you enter the BIOS and set is to a value near the current time and see if ntp is then able to sync.
restrict default kod nomodify notrap nopeer noquery restrict -6 default kod nomodify notrap nopeer noquery # Permit all access over the loopback interface.
If there's no BIOS update, I'd suggest taking it back and having the dealer replace it under warranty as it's clearly defective.
If I restart ntpd service the clock does update correctly.
According to /var/log/messages ntp doesn't try to sync again after the initial (re)start.
#crypto includefile /etc/ntp/crypto/pw # Key file containing the keys and key identifiers used when operating # with symmetric key cryptography.
keys /etc/ntp/keys # Specify the key identifiers which are trusted.